HP ProLiant DL280 Configuring Arrays on HP Smart Array Controllers Reference G - Page 90
Invalid Number of Parity Groups, Invalid Physical Disk Type Specified
View all HP ProLiant DL280 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
Error code Error message 2866 Failure opening capture file Comment or clarification slot for an available, active controller, or the controller is not available. - 2867 2868 2877 Failure opening input file Failure opening error file There are no suitable spares available - - ACU found no drives that could be used as spares for the specified array. 2880 Invalid Physical Disk Type Specified - 2882 Invalid MNP delay The specified value for MNP delay is invalid. 3000 Invalid Option The value of the option supplied to this parameter is invalid. 3002 3003 Command Failed License Key Delete Failed The controller returned an error for a command. ACU is unable to delete the license key. 3004 3005 3006 3007 3008 Invalid Sector Size Cannot delete Array Invalid Number of Parity Groups Chassis name is too long Chassis name is already in use - - - - Another controller is already using the entered chassis name. 3009 3010 3011 3012 3013 3014 3015 Auto Configure failed The Auto Configure mode was unable to complete auto configuration. Cannot extend logical drive, not enough - free space for the requested size Cannot extend logical drive, requested size - is too small Cannot specify both SIZE and SHRINKSIZE The input file cannot specify both a SIZE and SHRINKSIZE parameter. Cannot shrink Array The array shrink operation was not successful. Cannot move Array The array move operation was not successful. Invalid operation - Advanced Pack support The requested operation requires a valid license key required to be entered. 3016 3017 3018 3019 Spare drives cannot be specified by a count When in Reconfigure mode, the requested spare in Reconfigure mode drives must be specified by their addresses. A simple count cannot be used. Disk drives cannot be specified by a count in When in Reconfigure mode, the requested data Reconfigure mode drives must be specified by their addresses. A simple count cannot be used. Invalid number of physical disks - Cannot create Array - no physical disks specified ACU cannot create an array unless physical disks are specified in the input file DRIVE parameter. 3020 3021 SSP must be enabled in order to perform this For the specified operation, ACU requires SSP to be operation supported and enabled. Invalid connection name - HP Array Configuration Utility 90