HP ProLiant DL280 Configuring Arrays on HP Smart Array Controllers Reference G - Page 89

Error code 2836 2837 2838 2839 2841 2842 2843 2844 2849 2850 2851 2852 2853 2854 2857 2861 Error message Comment or clarification New Logical Drive ID does not match the The script file specifies a logical drive ID that is not next available logical drive ID. the first unused ID in the sequence. For example, this If you are attempting to replicate a message appears if the controller has only Logical configuration that has non-consecutive Drive 1 and the script file specifies creation of logical drive numbers, then you must Logical Drive 3 (omitting Logical Drive 2). A common change the script file so that the logical drive cause of this error is that the input file specifies numbers are consecutive. nonsequential logical drive numbers. In this case, change the logical drive numbers in the input file so that they are sequential. New Logical Drive ID already exists This error occurs in Configure mode when the logical drive ID specified in the script file already exists in the configuration. In Configure mode, you can create new logical drives only. Cannot create Logical Drive The array has no free space, or the maximum number of logical drives has been reached already. Cannot migrate Logical Drive RAID The controller does not support RAID migration, or migration is not possible with the current controller configuration. Cannot extend Logical Drive The controller does not support extension, or the current controller configuration cannot be extended. For example, extension is not possible if the array has no free space. Invalid RAID The specified RAID level is invalid or is not possible with the current physical disk and array configuration. Invalid Size The specified size is invalid or is not possible with the current configuration. Invalid Stripe Size The specified stripe size is invalid, not supported by the current RAID level, or not possible with the current configuration. Invalid ClearConfigurationWithDataLoss parameter Controller does not support Chassis Name The valid parameters are Yes and No (default). The controller does not support setting a chassis name. Invalid Chassis Name The entered chassis name is invalid. Use characters from the set a-z, A-Z, 0-9 and [space]. The name cannot end with a space character or exceed the maximum number of characters allowed by the controller. Invalid SSP State The requested SSP state is not a valid SSP state. Cannot change SSP settings The SSP settings cannot be changed for the controller or logical drive. Invalid SSP Adapter ID The adapter ID is not a valid adapter ID that was detected by the controller. Invalid Surface Scan Delay - Controller does not support redundancy settings The controller is not redundant or does not support redundancy settings. 2864 2865 Invalid Preferred Path Mode Invalid Preferred Path The specified value for the preferred path mode is not valid, or the controller is not available. The specified preferred path is not a valid chassis HP Array Configuration Utility 89