IBM 8651RM0 Hardware Maintenance Manual - Page 86
Hot-Swap Drive Installation
UPC - 087944340508
View all IBM 8651RM0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
Hot-Swap Drive Installation The two banks of bays on the right front of the server support hot-swap drives only. Attention You do not have to power-off the server to install hot-swap drives in these bays. However, you must power-off the server when performing any steps that involve installing or removing cables, except where instructed to do so when you are replacing a hot-swap fan. (See "Hot-Swap Fan Replacement" on page 83). 1 Filler panel 2 Hot-swap hard disk drive 3 Drive tray handle (open position) 78 Netfinity Server HMM
Hot-Swap Drive Installation
The two banks of bays on the right front of the server
support hot-swap drives only.
Attention
You do not have to power-off the server to install
hot-swap drives in these bays.
However, you must
power-off the server when performing any steps that
involve installing or removing cables, except where
instructed to do so when you are replacing a hot-swap
fan.
(See “Hot-Swap Fan Replacement” on page
83).
1
Filler panel
2
Hot-swap hard disk drive
3
Drive tray handle (open position)
78
Netfinity Server HMM