IBM 8651RM0 Hardware Maintenance Manual - Page 96
DC Power light
UPC - 087944340508
View all IBM 8651RM0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
Refer to the following illustration while performing the steps in this procedure. Note You do not need to power-off the server to install hot-swap power supplies. 1 Power supply 2 Bottom screw 3 Power switch on power supply 4 DC Power light 5 AC Power light 6 Top screw To add a power supply, do the following: Attention Before you install a power supply, set the Power switch on the power supply to the Off position. 1. Set the Power switch 3 on the back of the power supply to the Off position. 2. Locate the filler panel on the power-supply bay (at the back of the power-supply chassis). Attention For proper system cooling, do not operate the server for more than two minutes without a power supply or a filler panel installed for each of the power-supply bays. 3. Remove the two screws from the filler panel. 88 Netfinity Server HMM