IBM 8681 Hardware Maintenance Manual - Page 107
After the adjustment is made, tighten the, Install two screws through the slide-rail assembly
![]() |
UPC - 087944642503
View all IBM 8681 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
Clip nuts Cage nuts 3. Attach the slide-rail assemblies to the rack: Note The slide-rail assemblies are interchangeable. They contain a small amount of grease to lubricate the ball bearings. a. At the rear of the rack, position the slide-rail assembly on the mounting rail and align it over the cage nuts or clip nuts 1 . For the left slide-rail assembly, align the holes marked L (for left) over the cage nuts or clip nuts. For the right slide-rail assembly, align the holes marked R (for right) over the cage nuts or clip nuts. b. If required, loosen the nuts 2 on the rear section of the assembly and adjust the slide-rail assembly to fit over the front and rear mounting rails. After the adjustment is made, tighten the nuts. c. Install two screws through the slide-rail assembly and into the cage nuts or clip nuts. Do not tighten these screws. d. Make sure the slide-rail assembly mounting holes are over the cage nuts or clip nuts in the front mounting rail. e. With the latch tab pointing down, position the latch bracket 3 in front of the slide-rail assembly. Netfinity 8500R - Type 8681 99
![](/manual_guide/products/ibm-8500r-hardware-maintenance-manual-603c304/107.png)