IBM 8681 Hardware Maintenance Manual - Page 74
the static-protective package containing the memory
![]() |
UPC - 087944642503
View all IBM 8681 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
Refer to the following illustration while you perform the steps in this procedure. Note The illustrations in this section might differ slightly from your hardware. 1 Latches 2 Retaining clips 3 DIMM Before you begin: Read "Safety information" on page 240. Read the documentation that comes with your option. To install a DIMM: 1. Run the shutdown procedure for the operating system. Turn off the server and peripheral devices; then, remove the front bezel (see "Removing the front bezel" on page 137) and the memory-access panel (see "Removing the memory-access panel" on page 138). 2. If you are not installing an optional memory board, continue with step 3. If you are installing an optional memory board, touch the static-protective package containing the memory board to any unpainted metal surface on the server. Then, remove the memory board from the package. Continue with step 4 on page 67. 3. Remove the memory board from the server: a. Pull both latches 1 simultaneously so that they fully extend from the memory board. b. Grasp the two latches and pull the memory board from the server. 66 Netfinity Server HMM
![](/manual_guide/products/ibm-8500r-hardware-maintenance-manual-603c304/74.png)