IBM 8681 Hardware Maintenance Manual - Page 160

a. Pull the processor terminator card latches 4 so that they rotate to the unlocked position. b. Remove the processor terminator card 5 from the processor connector. c. Store the processor terminator card in a safe place. Note After you install the new processor in the server, place the terminator card in the empty static-protective bag. 4. If you are installing processors in the optional processor-daughterboard assembly, first follow the instructions in "Installing an optional processor daughterboard and cache coherency filter cards" on page 155; then, return here to continue. 5. If you are replacing a defective processor that was indicated by a processor failure LED and you need to verify its location, perform the following test. a. The eight processor error LEDs are located on the LED card, behind the processor housing assembly latches. Locate the words Press to show fault on the processor housing assembly. b. Press the indicated button adjacent to the words Press to show fault, and note the amber LEDs that indicate the defective processors, if any. If no amber LEDs illuminate and the green capacitor test LED adjacent to the word Testing does not illuminate, have the system serviced. c. Remove the defective processor and install a new one as described in this section. Removing the processor: a. Pull the processor latches 3 so that they rotate to the unlocked position. Attention Before you remove the processor, note the orientation of the original A1 processor. b. Remove the processor 6 from the processor connector. c. Set the processor aside. Refer to the processor option documentation for complete instructions on proper handling and disposal of a defective processor. 6. Install the processor: a. Touch the static-protective package containing the new processor to any unpainted metal surface on the server; then, remove the processor from the package. b. Rotate the processor latches 3 to the open position. 152 Netfinity Server HMM