IBM 8681 Hardware Maintenance Manual - Page 58
battery from under the battery clip., Place the I/O function card connector-side up
UPC - 087944642503
View all IBM 8681 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
b. Disconnect all cables 1 from the I/O function card 2 . Note carefully where each cable is connected before you remove it. See "I/O function card component locations" on page 120 for the connector locations on the I/O function card. c. Remove the two screws 4 located on the metal connector plate inside the server. d. Remove the I/O function card retention bracket 3 on the right side of the card by pulling out the fastener on the bracket. e. Carefully grasp the I/O function card by its top edge and pull the I/O function card out of the server. f. Place the I/O function card connector-side up on a flat, static-protective surface. 3. Locate the battery on the I/O function card (see "I/O function card component locations" on page 120). 4. Remove the battery: a. Use one finger to lift the battery clip over the battery. b. Use one finger to slightly slide the battery toward the rear of the I/O function card. The spring mechanism behind the battery will push it out toward you as you slide it forward. c. Use your thumb and index finger to pull the battery from under the battery clip. d. Ensure that the battery clip is touching the base of the battery socket by pressing gently on the clip. 5. Insert the new battery: a. Tilt the battery so that you can insert it into the front of the socket, under the battery clip. 50 Netfinity Server HMM