IBM 8681 Hardware Maintenance Manual - Page 230

System management codes The following page contains the system management codes. These codes are displayed on the front panel. Notes 1. See "System error log" on page 32 for instruction for viewing the error log. Check for additional information on all system managements codes. 2. To reset the system mangement adapter, shutdown the system and remove the power for 30 seconds. 3. Some of these codes will automatically be cleared once the problem is corrected. Others will need to be cleared manually. To ensure you have correctly identified the failing FRU during your diagnosis, manually clear any messages from the front panel display using the scroll and enter buttons on the right side of the front panel after you have replaced any FRU(s). This can be done with the system in the Standby mode before power up. Then, once you boot the system, if a problem still exists which normally generates a message on the front panel, the new message generated will alert you to the continued or new error condition. Table 16 (Page 1 of 5). System Management Codes Code/Description FRU/Action 00 (POST failed) 1. See the system error log and follow the instruction for the error in the log. 2. See "Undetermined problems" on page 211. 01 (POST warning) 1. See the system error log and follow the instruction for the error in the log. 08 (Application failed) 1. See the system error log and follow the instruction for the error in the log. 09 (Application warning) 1. See the system error log and follow the instruction for the error in the log. 10 (Boot failed) 1. Try to reboot the system. 2. See system error log for other possible errors. 3. See "Undetermined problems" on page 211. 18 (Operating system failed) 1. Restart the server. 222 Netfinity Server HMM