IBM 8681 Hardware Maintenance Manual - Page 76
Turn the DIMM, Install the DIMM
UPC - 087944642503
View all IBM 8681 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Attention To avoid breaking the retaining clips or damaging the DIMM connectors, handle the clips gently. 5. Install the DIMM: a. Turn the DIMM 3 so that the keys align correctly with the connector. b. Align the keyed DIMM 3 , and press on both sides of the DIMM as you insert it into the connector. Be sure to press the DIMM straight into the connector. Note If a gap exists between the DIMM and the retaining clips, the DIMM has not been properly installed. Open the retaining clips and remove the DIMM; then, reinsert the DIMM. c. Make sure that the retaining clips 2 are in the closed position. d. Repeat these steps for each DIMM that you install. 6. Reinstall the memory board: a. Insert the memory board into the guides and gently press the memory board into the connector. When you install the memory board in the server, be sure that it is correctly seated in the connector before you apply force to close the latches. b. Push the latches 1 until they close and lock in place. Attention To ensure proper EMC containment and cooling for the server, reinstall the memory-access panel before turning on the server. c. Reinstall the memory-access panel: 1) Ensure that the memory-access panel is fully seated in the appropriate location. 2) Press in the two plastic fasteners on the memory-access panel to secure it into place. d. Reinstall the front bezel (see "Installing the front bezel" on page 58). 7. If you have other options to install or remove, do so now; otherwise, continue with "Completing the installation" on page 56. 68 Netfinity Server HMM