IBM 8681 Hardware Maintenance Manual - Page 123
is open that is, perpendicular to the drive.
![]() |
UPC - 087944642503
View all IBM 8681 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 123 highlights
2. Remove the filler panel 1 from the empty hot-swap bay by inserting your finger into the depression at the left side of the filler panel and pulling it away from the server. Note If you are installing a slim-high drive, you must separate the slim filler bezel from the tray, and insert the slim filler bezel into the top of the hard disk drive cage. Otherwise, store the filler panel in a safe place. 3. Install the hard disk drive 2 in the hot-swap bay: a. Remove the new drive assembly from the static-protective package. b. Touch the static-protective package containing the drive assembly to any unpainted metal surface on the server. Then, remove the drive assembly from the static-protective package. c. If you are installing a slim-high drive, separate the slim filler bezel from the tray, and insert the slim filler bezel into the top of the hard disk drive cage. d. Ensure that the tray handle 3 is open (that is, perpendicular to the drive). e. Align the drive assembly so that it engages the guide rails in the bay. f. Gently push the drive assembly into the bay until the drive stops. g. Push the tray handle to the closed (locked) position. 4. Check the hard disk drive status indicators to verify that the hard disk drives are operating properly. Note If the server has a ServeRAID adapter installed, refer to the ServeRAID adapter documentation for details about configuration requirements. Record the configuration information. Netfinity 8500R - Type 8681 115
![](/manual_guide/products/ibm-8500r-hardware-maintenance-manual-603c304/123.png)