IBM 8681 Hardware Maintenance Manual - Page 159
Installing or replacing a processor, You may use
UPC - 087944642503
View all IBM 8681 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 159 highlights
Installing or replacing a processor: To install or replace a processor: Refer to the following illustrations while you perform the steps in this procedure. 1 Processor-cage cover 2 Fasteners on processor-cage cover 3 Processor latches 4 Terminator card latches 5 Processor terminator card 6 Processor and heat sink 1. Turn the four plastic fasteners 2 on the processor-cage cover 1 until they are in the unlocked position (one quarter-turn). You may use a flat-blade screwdriver or a coin. 2. Remove the processor-cage cover 1 and set it aside. 3. Determine the processor connector in which you want to install the new processor. If the connector contains a processor terminator card 5 : Netfinity 8500R - Type 8681 151
Installing or replacing a processor:
To install
or replace a processor:
Refer to the following illustrations while you perform the
steps in this procedure.
±1²
Processor-cage cover
±2²
Fasteners on processor-cage cover
±3²
Processor latches
±4²
Terminator card latches
±5²
Processor terminator card
±6²
Processor and heat sink
1.
Turn the four plastic fasteners
±2²
on the
processor-cage cover
±1²
until they are in the
unlocked position (one quarter-turn).
You may use a
flat-blade screwdriver or a coin.
2.
Remove the processor-cage cover
±1²
and set it
aside.
3.
Determine the processor connector in which you want
to install the new processor.
If the connector contains
a processor terminator card
±5²
:
Netfinity 8500R - Type 8681
151