IBM 88643RU Service Guide - Page 33
Configuration/Setup
UPC - 000435958211
View all IBM 88643RU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
- Memory Settings Select this choice to manually enable a pair of memory connectors. If a memory error is detected during POST or memory configuration, the server automatically disables the failing pair of memory connectors and continues operating with reduced memory. After the problem is corrected, you must manually enable memory connectors. Use the arrow keys to highlight the pair of memory connectors that you want to enable, and use the arrow keys to select Enable. - Memory hole remapping above 64 GB Select Disable to prevent memory gap remapping above 64 GB. Enable is the default setting. Memory gap remapping above 64 GB occurs when 64 GB of system memory is installed. The memory gap created for use by I/O devices is reclaimed above 64 GB. - CPU Options Select this choice to enable or disable the Hyper-Threading Technology. - Baseboard management controller (BMC) settings Select this choice to view information and to change baseboard management controller (BMC) settings. - BMC Firmware Ver This is a nonselectable menu item that displays the BMC firmware version. - BMC POST Watchdog Enable or disable the BMC POST watchdog. Disable is the default setting. - BMC POST Watchdog Timeout Set the BMC POST watchdog timeout value. 5 minutes is the default setting. - System-BMC Serial Port Sharing Enable or disable the system BMC serial port sharing. Enable is the default setting. - BMC Serial Port Access Mode Share or disable the BMC serial port access mode. Shared is the default setting. - Reboot System on NMI If you enable this option, the server automatically restarts 60 seconds after the service processor issues a nonmaskable interrupt (NMI) to the server. If you disable this option, the server does not restart. Enable is the default setting. - BMC Network Configuration Select this choice to view the BMC Network Configuration information. - BMC System Event Log To view the BMC System Event Log, which contains all system error and warning messages that have been generated. Use the arrow keys to move between pages in the log. If an optional IBM Remote Supervisor Adapter II SlimLine is installed, the full text of the error messages is displayed; otherwise, the log contains only numeric error codes. Run the diagnostic program to get more information about error codes that occur. See Chapter 5, "Diagnostics," on page 63 for instructions. Select Clear error logs to clear the BMC system event log. v Error Logs Select this choice to view or clear error logs. This choice is available on the full Configuration/Setup Utility menu only. - POST Error Log Chapter 2. Configuration information and instructions 17