IBM 88643RU Service Guide - Page 85
No-beep, symptoms
UPC - 000435958211
View all IBM 88643RU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved. v See Chapter 3, "Parts listing, Type 8864," on page 23 to determine which components are customer replaceable units (CRU) and which components are field replaceable units (FRU). v If an action step is preceded by "(Trained service technician only)", that step must be performed only by a trained service technician. Beep code Description Action One long and two short Card error. beeps 1. Reseat the following components: a. Microprocessor tray b. I/O board 2. Replace the following components one at a time, in the order shown, restarting the server each time. a. (Trained service technician only) Microprocessor tray b. I/O board Two long and two short Card error. beeps 1. Reseat the following components: a. Microprocessor tray b. I/O board 2. Replace the following components one at a time, in the order shown, restarting the server each time. a. (Trained service technician only) Microprocessor tray b. I/O board No-beep symptoms v Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved. v See Chapter 3, "Parts listing, Type 8864," on page 23 to determine which components are customer replaceable units (CRU) and which components are field replaceable units (FRU). v If an action step is preceded by "(Trained service technician only)", that step must be performed only by a trained service technician. No-beep symptom Description Action No beeps occur, and the system operates correctly. 1. (Trained service technician only) Reseat the operator information panel. 2. (Trained service technician only) Replace the operator information panel. No beeps occur after The power-on status is Disabled. successful completion of POST. 1. Run the Configuration/Setup Utility program and select Start Options; then, set Power-On Status to Enable. 2. (Trained service technician only) Reseat the operator information panel. 3. (Trained service technician only) Replace the operator information panel. No beeps occur, and there is no video. See "Solving undetermined problems" on page 156. Chapter 5. Diagnostics 69