IBM 88643RU Service Guide - Page 63
connector.
UPC - 000435958211
View all IBM 88643RU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
5. Touch the static-protective package that contains the DIMM to any unpainted metal surface on the outside of the server. Then, remove the DIMM from the package. 6. Turn the DIMM so that the DIMM keys align correctly with the slot. DIMM Retaining clip 7. Insert the DIMM into the connector by aligning the edges of the DIMM with the slots at the ends of the DIMM connector. 8. Firmly press one end of the DIMM into the connector; then, press the other end into the connector. The retaining clips snap into the locked position when the DIMM is seated in the connector. If there is a gap between the DIMM and the retaining clips, the DIMM has not been correctly inserted; open the retaining clips, remove the DIMM, and then reinsert it. 9. Repeat steps 4 through 8 to install any remaining DIMMs on the memory card. 10. Open the memory card retention levers on top of the memory card. 11. Press the memory card into the connector and close the small retention lever. 12. Wait two seconds and close the large retention lever. Chapter 4. Removing and replacing server components 47