Icom ID-5100A Full Instruction Manual - Page 225

Previous view 12 MENU SCREEN Menu items and Default settings NOTE: The default settings shown in bold letters below are for the USA version. The default settings may differ, depending on your transceiver version. DUP/TONE... Offset Freq Repeater Tone TSQL Freq Tone Burst DTCS Code DTCS Polarity Digital Code Settings to access repeaters. 0.000~0.600.00*1~59.995 MHz 67.0~88.5~254.1 Hz 67.0~88.5~254.1 Hz OFF or ON 023~754 Both N, TN-RR, TR-RN or Both R 00~99 Sets the frequency offset for duplex (repeater) operation. Selects a tone frequency used to access the repeaters. Selects a tone frequency for the Tone squelch or the pocket beep function. Turns the Tone Burst function ON or OFF. This function is used to suppress the squelch tail noise heard from the transceiver's speaker. Selects a DTCS (both encoder/decoder) code for DTCS squelch or the pocket beep function. Selects the DTCS polarity for the DTCS squelch or the pocket beep function. Selects a digital code for the Digital Code squelch function. Manage Memory Memory CH Call CH Manage your Memory or Call channel data. ALL, A~Z Manages for the Memory channels. C0/C1(144):146.010 FM*2 Manages for the Call channels. C0/C1(430):440.000 FM*2 Scan Pause Timer Resume Timer Temporary Skip Timer Set scan options. 2sec~10sec~20sec or HOLD 0sec~2sec~5sec or HOLD 5min, 10min or 15min Program Skip OFF or ON Bank Link A: ✔ ~Z: ✔ Program Scan Edge 00~24 Program Link See page 12-15 for details of the preset values. Selects the scan pause time. When receiving signals, the scan pauses according to the scan pause timer. Selects the scan resume time from a pause after the received signal disappears. Selects the Temporary Skip Time. When the time is set, specified frequencies are skipped for this period during a scan. Turns the Program Skip Scan function ON or OFF for a VFO mode scan. Selects banks to be scanned during a Bank Link Scan. Sets the frequency ranges for the program scan. Sets the link function for the program scan edge channels. Voice Memo QSO Recorder *3 Play Files*3 Recorder Set REC Mode RX REC Condition File Split PTT Auto REC Player Set Skip Time Set the TX/RX voice recording options. PLAY FILES Starts recording the received signal audio. Plays or deletes the recorded audio. TX&RX or RX Only Always or Squelch Auto OFF or ON OFF or ON Selects to record the TX audio or not. Selects whether or not the squelch status affects the RX voice audio recording. Selects whether or not to automatically create a new file if transmission and reception, or squelch status (open and close) is switched. Turns the PTT Automatic Recording function ON or OFF. 3sec, 5sec, 10sec or 30sec Sets the Skip time to rewind or forward the recorded audio when you push the fast-rewind or fast-forward key during playback. *1 The default value may differ, depending on the frequency band (selected as the MAIN band before entering the Menu screen) and the transceiver version. *2 The default value may differ, depending on the transceiver version. *3 Be sure to insert the SD card into the transceiver before selecting these items. 12-3