Icom ID-5100A Full Instruction Manual - Page 89
Accessing repeaters, Select your Access repeater
View all Icom ID-5100A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
Previous view 6 D-STAR OPERATION Accessing repeaters This section describes how to check whether or not you can access your local area repeater (Access repeater), and if your signal is successfully sent to a destination repeater. If your call sign (MY) has not been set, or your call sign and equipment have not been registered at a D-STAR repeater, see page 6-5 to 6-7. 1. Select your Access repeater ("FROM") qqTouch [DR]. wwCheck whether or not "FROM" is selected. • If "FROM" is not selected, touch the "FROM" field. eeTouch the "FROM" field. • Opens the "FROM SELECT" screen. 2. Select the Destination repeater ("TO") uuTouch the "TO" field. • Check whether "TO" is selected. iiTouch the "TO" field again. • Opens the "TO SELECT" screen. rrTouch "Repeater List." • Opens the "REPEATER GROUP" screen. ttTouch the repeater group where your access repeater is listed. (Example: "11: Japan") ooTouch "Gateway CQ." • Opens the "REPEATER GROUP" screen. !0 T ouch the repeater group where your destination repeater is listed. (Example: "11: Japan") !1 T ouch your destination repeater. (Example: "Hamacho") • Returns to the DR screen, and the selected repeater name is displayed in "TO." yyTouch your access repeater. (Example: "Hirano") • Returns to the DR screen, and the selected repeater name is displayed in "FROM." ☞☞Continued on the next page. Even if you select just the repeater name, the repeater call sign, its frequency, duplex setting, frequency offset and Gateway call sign are automatically set. 6-9