Icom VE-PG4 Installation Guide ver.1.34 - Page 43

2 Setting up the transceivers NXDN Conventional mode operation ■■Connecting the transceiver to the RoIP Gateway 1 Set the transceiver channel, volume level, TX output power, and other necessary settings, before connecting to the RoIP Gateway. NOTE: Turn OFF both the RoIP Gateway and the transceiver before connecting the cable. 2 Connect the RoIP Gateway and the transceiver, using the appropriate optional cable. VE-PG4 (Rear view) A1~A4 B1~B4 C1~C4 A1~A4 B1~B4 C1~C4 A1~A4 B1~B4 C1~C4 A1~A4 B1~B4 C1~C4 Icom transceiver (IC-F5060/IC-F6060) (Rear view) To [EXT1] (Lower slots) A1~A4 B1~B4 C1~C4 A BC Be sure to insert the connectors top side up ABC 1234 Top A Bottom OPC-2275 To the external speaker jack (Front view) To the microphone connector LLThe [EXT1] and [EXT2] ports (lower slots) accept transceivers, by default. 3 Turn ON the transceiver and the RoIP Gateway. NOTE: ••Turn OFF both the radio and the RoIP Gateway when connecting or disconnecting the transceiver. ••Keep the radio away from a PC, AC adapter and other electronic equipment. The noise emitted from those equipment may interfere with the radio. ••When operating the radio, do not transmit near the IP telephone. NOTE: 4 Internal AMBE+2 vocoders can be assigned to the digital transceivers. If you need an additional AMBE+2 vocoder, an optional CT-24 digital voice converter is required. Cushion leg Status Indicator Lights green: Power ON Blinks orange: Communicating Cushion sheet (Supplied with the CT-24) CT-24 USB cable (supplied with the CT-24) Before connecting the cable, turn OFF the VE-PG4. 2-18