Icom VE-PG4 Installation Guide ver.1.34 - Page 68
The Status
![]() |
View all Icom VE-PG4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
3 Wireless LAN transceivers Configuring the wireless LAN transceiver system Transceiver Controller > Common Settings > Status ■■The Status Enter a status that the IP100H will transmit. LLSet "Status" to "Enable" to use the status. (Transceiver Controller > Transceiver Settings > Transceiver Settings > Transceiver Settings) LLAfter completing the settings on this screen, restart the IP100H to apply them. 1 Open the Status screen. (Transceiver Controller > Common Settings > Status) 2 Enter status message of up to 32 characters, and then click . LLUp to 10 status messages can be entered. LLUncheck the box on the left of the status message, if you do not want to display it on the IP100H. q Enter w Click 3-13
![](/manual_guide/products/icom-vepg4-installation-guide-ver134-2d38ea1/68.png)
3
WIRELESS LAN TRANSCEIVERS
3-13
Configuring the wireless LAN transceiver system
■
The Status
Enter a status that the IP100H will transmit.
L
Set “Status” to “Enable” to use the status.
(Transceiver Controller > Transceiver Settings > Transceiver Settings > Transceiver Settings)
L
After completing the settings on this screen, restart the IP100H to apply them.
1
Open the Status screen.
(Transceiver Controller > Common Settings > Status)
2
Enter status message of up to 32 characters, and then click <Apply>.
L
Up to 10 status messages can be entered.
L
Uncheck the box on the left of the status message, if you do not want to display it on the IP100H.
q
Enter
w
Click
Transceiver Controller > Common Settings > Status