Intel SR2600UR Service Guide - Page 129
Installing the Backplane, Removing the Midplane Board,
![]() |
UPC - 735858206778
View all Intel SR2600UR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 129 highlights
A B C AF003110 Figure 102. Removing the Backplane from the Intel® Server System SR2625UR Installing the Backplane To install the backplane, follow these steps: 1. Remove the midplane board. For instructions, see "Removing the Midplane Board" on page 102. 2. Remove all hot-swap drive carriers, regardless of whether or not a drive is installed in the carrier. For instructions, see "Removing a SAS or SATA Hot-swap Hard Disk Drive" on page 74. 3. Depending on your server system, do one of the following: For Intel® Server System SR2600UR, do the following: a. Hold the backplane only by the edges. Do not push or pull on any components on the backplane. Set the backplane in place at the front of the server system, with the sides of the board resting in the guides at the left and right sides of the server system. b. Slide the backplane into the server system guides at the left and right sides of the server system until the pins at the left and right sides of the backplane bracket are Intel® Server System SR2600UR/SR2625UR Service Guide 109
![](/manual_guide/products/intel-sr2600ur-service-guide-1ac9b07/129.png)