Intel SR2600UR Service Guide - Page 72

Replacing a PCI Riser Card Caution: PCI riser cards are NOT hot-swappable. Before removing or replacing the riser card, you must first take the server out of service, turn off all peripheral devices connected to the system, turn off the system by pressing the power button, and unplug the AC power cord from the system or wall outlet. Note: To eliminate the possibility of installing the replacement connector on the wrong side of the PCI riser assembly, replace one connector at a time. Removing a PCI Riser Card To remove a PCI Riser Card, follow these steps: 1. Disconnect any cables attached to any add-in cards. 2. Remove the PCI riser assembly. For instructions, see "Removing the PCI Riser Assembly" on page 50. 3. Remove any add-in cards from the PCI riser card. For instructions, see "Removing a PCI Add-in Card" on page 55. 4. Push back on the blue release lever at the end of the riser card (see letter "A" in Figure 34). 5. While holding the lever back, slide the card firmly in the direction shown to disengage the card from the riser pins (see letter "B" in Figure 34) and remove from the riser assembly (see letter "C" in Figure 34). A Riser Retention Pin B C Riser Card AF003012 Figure 34. Removing the PCI Riser Card from the Server System (Full-height Side) 6. Install the replacement riser card, if desired. For instructions, see "Installing PCI Riser Card into the Server System" on page 53. 52 Intel® Server System SR2600UR/SR2625UR Service Guide