Netgear DG834G DG834Gv4 Reference Manual - Page 153
Configuration Summary (Telecommuter Example), ping 172.23.9.1
UPC - 606449029918
View all Netgear DG834G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 153 highlights
ADSL2+ Modem Wireless Router DG834G Reference Manual 6. Test the VPN tunnel by pinging the remote network from a PC attached to the DG834G v4. a. Open the command prompt (Start -> Run -> cmd) b. Type ping 172.23.9.1 Figure B-12 Note: The pings might fail the first time. If this happens, try the pings a second time. Configuration Summary (Telecommuter Example) The configuration in this section follows the addressing and configuration mechanics defined by the VPN Consortium. Gather all the necessary information before you begin the configuration process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and all of the parameters that need to be set on both sides. Assure that there are no firewall restrictions. Table B-3. Configuration Summary (Telecommuter Example) VPN Consortium Scenario: Type of VPN: Security Scheme: IP Addressing: Gateway Client Scenario 1 PC/client-to-gateway, with client behind NAT router IKE with Pre-shared Secret/Key (not certificate-based) Fully Qualified Domain Name (FQDN) Dynamic NETGEAR VPN Configuration v2.0, September 2007 B-11