Netgear DG834Gv1 DG834Gv2 Reference Manual - Page 110

Reference Manual for the Model Wireless ADSL Firewall Router DG834G Table 8-1. VPN Tunnel Configuration Worksheet Connection Name: Pre-Shared Key: Secure Association -- Main Mode or Manual Keys: Perfect Forward Secrecy -- Enabled or Disabled: NETBIOS -- Enabled or Disabled: Encryption Protocol -- DES or 3DES: Authentication Protocol -- MD5 or SHA-1: Diffie-Hellman (DH) Group -- Group 1 or Group 2: Key Life in seconds: IKE Life Time in seconds: VPN Endpoint Local IPSec ID LAN IP Address Subnet Mask FQDN or Gateway IP (WAN IP Address) To set up a VPN connection, you must configure each endpoint with specific identification and connection information describing the other endpoint. You must configure the outbound VPN settings on one end to match the inbound VPN settings on other end, and vice versa. This set of configuration information defines a security association (SA) between the two VPN endpoints. When planning your VPN, you must make a few choices first: • Will the local end be any device on the LAN, a portion of the local network (as defined by a subnet or by a range of IP addresses), or a single PC? • Will the remote end be any device on the remote LAN, a portion of the remote network (as defined by a subnet or by a range of IP addresses), or a single PC? • Will either endpoint use Fully Qualified Domain Names (FQDNs)? FQDNs supplied by Dynamic DNS providers (see "The Use of a Fully Qualified Domain Name (FQDN)" on page F-7) can allow a VPN endpoint with a dynamic IP address to initiate or respond to a tunnel request. Otherwise, the side using a dynamic IP address must always be the initiator. 8-4 Virtual Private Networking (Advanced Feature) 202-10006-05, June 2005