Netgear DG834Gv1 DG834Gv2 Reference Manual - Page 136
Start Using a VPN Tunnel to Active It, Verifying the Status of a VPN Tunnel
View all Netgear DG834Gv1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 136 highlights
Reference Manual for the Model Wireless ADSL Firewall Router DG834G Once the connection is established, you can open the browser of the PC and enter the LAN IP address of the remote DG834G. After a short wait, you should see the login screen of the Router (unless another PC already has the DG834G management interface open). • Gateway-to-Gateway Configuration-test the VPN tunnel by pinging the remote network from a PC attached to the DG834G. a. Open command prompt (i.e., Start -> Run -> cmd). b. ping 192.168.3.1. Figure 8-34: Pinging test results Note: The pings may fail the first time. If so, then try the pings a second time. Start Using a VPN Tunnel to Active It To use a VPN tunnel, use a Web browser to go to a URL whose IP address or range is covered by the policy for that VPN tunnel. Verifying the Status of a VPN Tunnel To use the VPN Status page to determine the status of a VPN tunnel, perform the following steps: 1. Log in to the Router. 2. Open the DG834G management interface and click on VPN Status to get the VPN Status/Log screen (Figure 8-35). Log-this log shows the details of recent VPN activity, including the building of the VPN tunnel. If there is a problem with the VPN tunnel, refer to the log for information about what might be the cause of the problem. • Click Refresh to see the most recent entries. • Click Clear Log to delete all log entries. 8-30 Virtual Private Networking (Advanced Feature) 202-10006-05, June 2005