Panasonic AG-MDC20GJ / AG-MDR25PJ AG-MDR25 Camera Recorder Operating Instructi - Page 10

∫ Cautions for use About this unit The unit and the SD card become warm during use. This is not a malfunction. Keep this unit as far away as possible from electromagnetic equipment (such as microwave ovens, TVs, video games etc.). ≥ If you use this unit on top of or near a TV, the pictures and/or sound on this unit may be disrupted by electromagnetic wave radiation. ≥ Do not use this unit near cell phones because doing so may result in noise adversely affecting the pictures and/or sound. ≥ Recorded data may be damaged, or pictures may be distorted, by strong magnetic fields created by speakers or large motors. ≥ Electromagnetic wave radiation generated by microprocessors may adversely affect this unit, disturbing the pictures and/or sound. ≥ If this unit is adversely affected by electromagnetic equipment and stops functioning properly, turn this unit off and remove the battery or disconnect AC adaptor. Then reinsert the battery or reconnect AC adaptor and turn this unit on. Do not use this unit near radio transmitters or highvoltage lines. ≥ If you record near radio transmitters or high-voltage lines, the recorded pictures and/or sound may be adversely affected. About connecting to a PC ≥ Please use a commercially available cable compatible with the USB 2.0 standard. Connect a miniB terminal to this unit. When connecting to the dedicated Camera Head (AG-MDC20G) ≥ Always use a genuine Panasonic Camera head option cable (AG-C20003G (3 m (118-1/8 q)), AG-C20020G (20 m (787-3/8 q)): optional). When connecting to a network ≥ LAN cable* (category 5 or above), max. 100 meters (328 feet) * Use of an STP (shielded twisted pair) cable is recommended. When connecting to an SDI input/output device ≥ To connect to the SDI IN terminal or SDI OUT terminal, use a double-shielded BNC cable equivalent to 5C-FB (commercially-available). Note on viewing motion pictures/still pictures on an external monitor ≥ Use a commercially-available High Speed HDMI cable. If possible, we recommend using a cable with a length of 3 m (9.84 feet) or less. Make sure to use the supplied cords. If you use optional accessories, use the cords and the cables supplied with them. Do not extend the cords and the cables. Do not spray insecticides or volatile chemicals onto the unit. ≥ If the unit is sprayed with such chemicals, its body may be marred and the surface finish may peel off. ≥ Do not leave rubber or plastic products in contact with the unit for a long time. When you use the unit in a sandy or dusty place such as a beach, do not let sand or fine dust get into the body and terminals of the unit. Also, keep the unit away from sea water. ≥ Sand or dust may damage the unit. (Care should be taken when inserting and removing a card.) ≥ If sea water splashes onto the unit, wipe off the water with a well wrung cloth. Then wipe the unit again with a dry cloth. When carrying the unit, do not drop or bump it. ≥ A strong impact can break the unit's casing, causing it to malfunction. Maintenance Inspections ≥ For your safety, it is recommended that maintenance inspections are carried out on an annual basis. Cleaning When cleaning, do not use benzine or thinner. Using benzine or paint thinners may deform the recorder and/or cause the surface finish to peel off. Cleaning procedure 1. When cleaning, unplug the power cord and remove the battery. 2. Use a soft, clean cloth to wipe the recorder. To remove stubborn dirt, wipe the recorder with a cloth moistened with neutral detergent that has been diluted with water and then use a dry cloth to take up the remaining moisture. 3. Use a cloth moistened in ethanol for disinfection and thoroughly wrung out to remove dust and dirt from the recorder. 4. Be sure to thoroughly dry the recorder after cleaning it with ethanol for disinfection. When you are not going to use the unit for an extended time ≥ When storing the unit, it is recommended that you place a desiccant (silica gel) in with it. About terminal protection ≥ When not using the connecting terminal, please attach the cover. Do not allow the cord to drag on the ground or pull a connected cord along the passage ≥ The cord will be damaged, causing fire or electrical shock, when the cord gets caught by the feet, excite will also cause personal injury. Please use this unit at least 30 cm (0.98 feet) from surrounding walls. - 10 -