Panasonic AG-MDC20GJ / AG-MDR25PJ AG-MDR25 Camera Recorder Operating Instructi - Page 72

≥ Register to a USER button. (l 66) Approximately 3 seconds at the last of the clip recorded last can be played back. It will return to the recording screen once the playback is completed. ≥ The time code is not displayed during REC check. ≥ This does not operate during REC check even if the button is operated. ≥ Recording Check is not possible in following cases: j When the unit is turned on/off j When the MODE button is pressed j When the SD card is inserted/removed j When the setting of [REC FORMAT] is changed (l 213) j PRE-REC is used (l 71, 215) j During Freeze Frame (l 70) ≥ Register to a USER button. (l 66) The clip recorded last can be deleted. Deleted clips cannot be restored. 1 Press USER button or touch USER button icon in the recording screen. 2 Touch [YES]. ≥ It will return to recording screen without deleting by touching [NO]. ≥ Deletion is not possible in the following cases. j When the unit is turned on/off j When the MODE button is pressed j When the SD card is inserted/removed j When the setting of [REC FORMAT] is changed (l 213) ≥ Register to a USER button. (l 66) This controls recording performed with an external device (recorder, etc.) connected to the unit. ≥ Set [SDI MODE SEL] to [NORMAL]. (l 95) 1 Select the appropriate option in the [OUTPUT SEL] menu. OUTPUT SETUP] # [OUTPUT SEL] # [SDI] 2 Select the [SDI REMOTE REC] menu. OUTPUT SETUP] # [SDI REMOTE REC] # [TYPE3] 3 Select the [SDI REMOTE REC LINK] menu. OUTPUT SETUP] # [SDI REMOTE REC LINK] # [OFF] 4 Press USER button or touch USER button icon in the recording screen. ≥ This will display and send a signal to the external device instructing it to start recording. ≥ To stop recording to the external device, press the applicable USER button or touch the applicable USER button icon again. This will display and send a signal to the external device instructing it to stop recording. ≥ It is not possible to control recording performed with an external device connected to the SDI OUT terminal in the following cases: j When [SDI MODE SEL] is set to [THROUGH] - 72 -