Panasonic AG-MDC20GJ / AG-MDR25PJ AG-MDR25 Camera Recorder Operating Instructi - Page 74

≥ Register to a USER button. (l 66) The color bar convenient for picture quality adjustment of the external monitor can be displayed. ≥ Test tones can be output as audio signals from the headphone terminal or either of the external output terminals while color bars are displayed. It will not be output from the speaker of this unit. ≥ Different color bars are displayed depending on the [BARS TYPE] setting. (l 224) ≥ The frequency of a test tone that is output when color bars are displayed differs depending on the setting of the following items: j [SYSTEM FREQ] (l 41) j Frame rate in [REC FORMAT] (l 213) System Frequency setting 59.94Hz 50.00Hz Frame rates All frame rates 50.00p/50.00i/25.00p Test tone frequency 1 kHz 997 Hz ≥ The test tone volume differs depending on the [TEST TONE] setting. (l 221) ≥ This function is canceled when the unit is turned off. ≥ You can record color bars as motion pictures. ≥ If you press the USER button while recording color bars as a motion picture, you can stop displaying the color bars. To display them again, stop the recording and press the USER button. ≥ To output the color bar from the SDI OUT terminal, set [SDI MODE SEL] to [NORMAL]. ≥ This item cannot be set during Freeze Frame. (l 70) ≥ Color bars can be displayed and recorded during SDI Mode even when there is no SDI input. ≥ If you display color bars while an error message about SDI input is displayed on the unit's screen, built-in color bars will appear. (l 96) ≥ While built-in color bars are displayed, input information (TC/UB, etc.) will be provided by the unit. Test tones can be output as audio signals. ≥ If you cancel the color bar display and stop recording, built-in color bars will disappear and the unit will switch to SDI Mode. ≥ When an SDI signal is input to the unit while built-in color bars are displayed, genlock will be applied (the unit will stop and then restart recording if this occurs during recording). However, the color bars will remain displayed. The SDI input screen will appear after the color bar display is canceled. ≥ To output color bars to the SDI OUT terminal, set [SDI MODE SEL] to [NORMAL]. (l 95) ≥ Register to a USER button. (l 66) The counter display can be switched. (l 63) ≥ Register to a USER button. (l 66) The display of the recording time counter can be reset. (l 65) ≥ Register to a USER button. (l 66) The outline of the LCD monitor image is enhanced, making it easier to focus. (l 50) ≥ These settings will not affect the images actually recorded. - 74 -