Panasonic AG-MDC20GJ / AG-MDR25PJ AG-MDR25 Camera Recorder Operating Instructi - Page 171

Password Enter the password for accessing the FTP server. Maximum number of characters 0 to 32 half-size characters Characters that can be entered Half-size alphanumeric characters, half-size symbols However, the following characters cannot be entered. " & Factory settings: blank ≥ When you enter a password and click the [Set] button, nothing is displayed in the input field but the setting is complete. Control port Enter the port number for FTP server control. Port Nos. that can be selected: 1 to 65535 The following port numbers are used by the unit so they cannot be used. 20, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 443, 554, 995, 10669, 10670, 59000 to 61000 Factory settings: 21 FTP mode Select the FTP communication mode from Passive mode and Active mode. Factory settings: Active ¥ NTP Settings relating to the NTP server address and port No. are performed. This item's setting is reflected when the [Set] button is pressed. Synchronization with NTP Set whether to use an NTP server by selecting "On" or "Off". Setting value: On Uses an NTP server. (Synchronizes the date and time with the NTP server.) Off Does not use an NTP server. Factory settings: Off NTP server address setting Select the method to acquire the NTP server address. Setting value: Auto Acquires the NTP server address from the DHCP server. Manual Sets the address by inputting the NTP server address in [NTP server address]. Factory settings: Manual ≥ To acquire the NTP server address from the DHCP server, you need to set "DHCP" (l 167) of "IPv4 network" on the [Network] tab of the network setup screen [Network] to "On". - 171 -