Panasonic AG-MDC20GJ / AG-MDR25PJ AG-MDR25 Camera Recorder Operating Instructi - Page 64
DF MODE], TC PRESET], Select the menu., Touch the item to set and change
View all Panasonic AG-MDC20GJ / AG-MDR25PJ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
[DF MODE] Select the compensation mode for the time code. ≥ Set [SYSTEM FREQ] to [59.94Hz]. (l 41) Select the menu. TC/UB SETUP] # [DF MODE] # desired setting [DF]: [NDF]: Time code is compensated in accordance with the actual time. It is mainly used for broadcasting such as TV programs. It will not compensate the time code. (There will be a difference from the actual time) ≥ This item will be set to [NDF] automatically in following cases: j When the frame rate in [REC FORMAT] is 23.98p (l 213) ≥ This item will be automatically set to [NDF] and will not be displayed as a menu item when [SYSTEM FREQ] is set to [50.00Hz]. (l 41) [TCG] Sets the way the time code will move. Select the menu. TC/UB SETUP] # [TCG] # desired setting [FREE RUN]*: It will constantly move. [REC RUN]: It will move only when recording. * If the frame rate in [REC FORMAT] or is set to 23.98p, a slight time error may occur when switching to Playback Mode. (l 213) ≥ It is automatically set to [FREE RUN] in following cases: j When PRE-REC is enabled (l 71, 215) ≥ The time code will reset when the built-in lithium battery is exhausted when it is set to [FREE RUN]. [TC PRESET] You can set the initial time code. 1 Select the menu. TC/UB SETUP] # [TC PRESET] 2 Touch the item to set and change with / . ≥ The display will be set to "00h00m00s00f" if you touch [Reset]. ≥ "h" is an abbreviation for hour, "m" for minute, "s" for second and "f" for frame. 3 Touch [EXIT] to complete the setting. ≥ This unit will adjust the time code in accordance with the frame rate of the [REC FORMAT] (l 213). Therefore, it may not be continuous from the previous final time code when the recording format is changed. ≥ Counting may not continue from the previous final time code when the Operation Mode is switched from SDI Mode to CAM Mode. ≥ If the frame rate in [REC FORMAT] is set to 23.98p, set the number of frames to [00] or a multiple of 4. If you enter a different value, time code will not be recorded correctly. - 64 -