Sanyo 26KHS72R Installation Instructions - Page 105
X, T, U, K Type
![]() |
View all Sanyo 26KHS72R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
07-115 SSHP_II 5/7/07 4:00 PM Page 105 I X, T, U, K Type 11-2. Caution G This unit may be used in a single-type refrigerant system where 1 outdoor unit is connected to 1 indoor unit. G The indoor and outdoor unit control PCBs utilize a semiconductor memory element (EEPROM). The set- tings required for operation were made at the time of shipment. Only the correct combination of indoor and outdoor units can be used. G This test run manual describes primarily the procedure when using the wired remote controller. 11-3. Test Run Procedure Recheck the items (see 11-4) to check before the test run. Check the combination (wiring) of indoor and outdoor units. (See 5-3) Turn ON the indoor and outdoor power. Automatic NO address? YES Check the warning code. Set the remote controller to "test run." (See 10-5) Has the NO test run been completed? YES Return the remote controller to normal control. Refer to "Table of Self-Diagnostic Functions and Corrections" to check the system. Note: Check the indoor-side drainage. Fig. 11-3 105
![](/manual_guide/products/sanyo-26khs72r-installation-instructions-5d29d01/105.png)