Sanyo 26KHS72R Installation Instructions - Page 85
How To In, Tall The, Tem Controller, Optional Part
View all Sanyo 26KHS72R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
07-115 SSHP_II 5/7/07 4:00 PM Page 85 8. HOW TO INSTALL THE SYSTEM CONTROLLER (OPTIONAL PART) Do not supply power to the unit or try to operate it until the tubing and wiring to the outdoor unit are completed. 8-1. System Controller Installation CAUTION Do not twist the control wiring with the power wiring or run it in the same metal conduit, because this may cause malfunction. Install the system controller away from sources of electrical noise. Install a noise filter or take other appropriate action if electrical noise affects the power supply circuit of the unit. Switch box (with cover) M4 × 1-3/16 in. Screws (2) System controller Flat-top Screw Fig. 8-1 Back case (1) Remove the flat-top screw on the bottom of the back case. When you open up the decorative cover, you will see two gaps under the system controller. Insert a coin into these gaps and remove the back case. (Figs. 8-1, 8-2) (2) Connect the wires to terminal base of the system controller (see next page). (3) Attach the back case with the 2 M4 screws provided. Gap Gap Coin Fig. 8-2 (4) To finish, fit the back tabs of the back case into the system controller and mount it using the flat- top screw. SC 85