Sanyo 26KHS72R Installation Instructions - Page 41

07-115 SSHP_II 5/7/07 4:00 PM Page 41 3-14. Preparing the Indoor Side Tubing KH(S)2672R Arrangement of tubing by directions (a) Right tubing The corner of the right frame needs to be cut by a hacksaw or the like. (Fig. 3-46) (b) Right-rear or left-rear tubing In this case, the corner of the frame need not be cut. To mount the indoor unit on the rear panel: (a) Hang the 3 mounting slots of the unit on the upper tabs of the rear panel. (Fig. 3-47) KH(S)3072R, KH(S)3672R Tubing can be extended in 4 directions as shown in Fig. 3-54. Arrangement for Right-rear Tubing (a) Remove the 2 screws and slide out the side cover. (Fig. 3-48) (b) Extend the gas tube from the outdoor side and connect it directly to the mating tube inside the indoor unit. Use a flare nut. (Fig. 3-49) Arrangement for Right Tubing (a) Remove the 2 screws and take off the side cover. (Fig. 3-48) (b) Cut out the L-shaped tubing outlet using a hacksaw. (Fig. 3-50) (c) Using the L-shaped tube (field supply), connect tubing between the indoor and outdoor units. (Fig. 3-52) Arrangement for Left and Left-rear Tubing. (a) Remove the 4 screws (2 on each side) and take off both left and right side cover. (Fig. 3-51) (b) Remove 4 screws to remove the bottom cover. (c) Using the L-shaped tube (field supply), connect tubing as in Fig. 3-53. Frame Right tubing outlet Fig. 3-46 Mounting slot Tab K Fig. 3-47 Tubing from the outdoor unit Fig. 3-48 Fig. 3-49 Hacksaw Fig. 3-50 Indoor unit Left side cover Bottom cover Fig. 3-51 Right side cover L-shaped tube L-shaped tube Fig. 3-52 41 Fig. 3-53