Sanyo 26KHS72R Installation Instructions - Page 78
Ba, ic Wirin, ure to do the wirin, correctly incorrect wirin, will dama, e the e, ment., Wirin,
![]() |
View all Sanyo 26KHS72R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
07-115 SSHP_II 5/7/07 4:00 PM Page 78 7-16. Basic Wiring Diagram CAUTION Be sure to do the wiring correctly (incorrect wiring will damage the equipment). Remote controller 12 Wire joint 12 Indoor unit No. 1 U1 U2 Inter-unit control wiring U1 U2 Outdoor unit : Ground (earth) Use shielded wires for inter-unit control wiring and ground the shield on both sides. (Fig. 7-25) Otherwise misoperation because of electrical noise may occur. Shielded wire Ground Ground Fig. 7-25 RC (WL) Wiring procedure Carry out the wiring according to the above wiring diagram. Address setting is automatically executed after turning on the system. An indoor unit address is assigned to each indoor unit. Operation takes place successively at intervals of 1 second, by using combinations of the address setting of each unit. 78
![](/manual_guide/products/sanyo-26khs72r-installation-instructions-5d29d01/78.png)