Sanyo 26KHS72R Installation Instructions - Page 92
Zone re, tration u, tem controller, HA-KC64UG
View all Sanyo 26KHS72R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
07-115 SSHP_II 5/7/07 4:00 PM Page 92 (b) Zone registration using the system controller (SHA-KC64UG) In this case, you set all central addresses by the system controller at once manually. (1) Press the and ZONE buttons at the same time for more than 4 seconds. and CODE No. C1 will flash. (2) After confirming that CODE No. C1 is displayed, If data is registered press the button. Once in this mode, a the unit No. change takes place as shown in Fig. 8-8. is displayed. ZONE 1 2 3 4 6 ZONE 9 SELECT ZONE GROUP If no data is registered no number is displayed. Selected group No. if no data is registered. (3) Select the zone and group No. you want to set with ZONE and (GROUP) buttons. If already set, press the buttons. (4) Set the unit No. (indoor unit address) with and buttons, according to the zone registration table. R.C. No button Indoor unit No button Fig. 8-8 ZONE 1 2 3 4 ZONE 9 67 (5) Press the button. GROUP No. turns ON and UNIT No. (indoor unit address) changes from flashing to ON state. UNIT No. is registered to the selected ZONE No. and GROUP No. If you make a mistake, press the button SELECT ZONE GROUP and reselect the ZONE, GROUP and UNIT No. (6) Register the other UNIT Nos. in the same way by following steps (3) to (5). For example, in this case Zone 3, Group No. 7 Unit No. (indoor unit address) 2-8 (7) Finally, complete the registration by pressing the button. flashes for a few minutes, then turns OFF. SC Unit No. 2-8 is registered to Zone 3, Group 7. Fig. 8-9 92