Sanyo 26KHS72R Installation Instructions - Page 93
Automatic zone re, tration u, controller, HA-KC64UG
View all Sanyo 26KHS72R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
07-115 SSHP_II 5/7/07 4:00 PM Page 93 (c) Automatic zone registration using the system controller (SHA-KC64UG) (1) Press the and buttons at the same time for more than 4 seconds. and CODE No. C1 will flash. (2) Select CODE No. C2 by pressing and ( ) button and press the button. C2 changes from flashing to ON state and automatic zone registration will start. (3) Any registered GROUP Nos. will be erased. (4) Central address will be assigned from the smallest indoor unit address to larger ones in numerical order automatically. On finishing automatic zone registration, changes from flashing to OFF. (5) If an error occurs, "CHECK" starts flashing and zone registration finishes at this time. Press the button to start over. (6) Finally, complete automatic zone registration mode by pressing the button. flashes for a few minutes, then turns OFF. Fig. 8-10 SC 93