Sanyo 26KHS72R Installation Instructions - Page 16

07-115 SSHP_II 5/7/07 3:59 PM Page 16 2. SELECTING THE INSTALLATION SITE 2-1. Indoor Unit AVOID: G areas where leakage of flammable gas may be expected. G places where large amounts of oil mist exist. G direct sunlight. G locations near inverter lamps which may affect the performance of the unit. G locations near heat sources which may affect the performance of the unit. G locations where external air may enter the room directly. This may cause "sweating" on the air discharge ports, causing them to spray or drip. G locations where the remote controller will be splashed with water or affected by dampness or humidity. G installing the remote controller behind curtains or furniture. G locations where the receiver in the indoor unit is exposed to the inverter lamp light. Faulty operation of the unit occurs. DO: G select an appropriate position from which every corner of the room can be uniformly cooled. G select a location where the ceiling is strong enough to support the weight of the unit. G select a location where tubing and drain pipe have the shortest run to the outdoor unit. G allow room for operation and maintenance as well as unrestricted air flow around the unit. G install the unit within the maximum elevation difference above or below the outdoor unit and within a total tubing length (L) from the outdoor unit as detailed in Table 1-11. G allow room for mounting the remote controller about 3 ft. off the floor, in an area that is not in direct sunlight nor in the flow of cool air from the indoor unit. NOTE Air delivery will be degraded if the distance from the floor to the ceiling is greater than 10 ft. Ceiling-Mounted Type Ceiling Wall Min. 10 inch Front view Min. 10 inch NOTE The rear of the indoor unit can be installed flush against the wall. Air discharge Ceiling Min. 2 ft. Air intake Side view Max 25 cm 4-Way Air Discharge Type Concealed-Duct Type 3 ft. 3 ft. 3 ft. 3 ft. 3 ft. Wall-Mounted Type Min. 6 inch Min. 6 inch Min. 12 inch 16