Sony HDWS280 Product Manual (Operation Manual 1st Edition (Revised 5)) - Page 52

Stop Code 7 Chapter 7-1 Stop Code 7-2 Stop Code Operation You can record, detect, and erase stop codes conforming to the NAB-T007-1990 standards. The stop code is recorded for 20 frames at a point four seconds before the SOM (start of program). When this code is detected during playback, the tape stops at the designated point. The point to stop the tape can be adjusted by modifying the following two settings: • Point to stop the tape after detecting the stop code: 0 to 30 frames in units of frames • Point to start recording the stop code: 1 to 5 seconds in units of seconds (to SOM) The recording format of the stop code is as shown below. This section describes the operations for detecting or recording stop codes. 7-2-1 Detecting the Stop Code Detecting the stop code Function buttons Menu display area Condition area HDW-S280 EJECT Tape direction Stop position SOM Stop code Adjustable 20 frames 3 seconds (adjustable) 4 seconds PB LEVEL 13 REC LEVEL 13 24 24 R/P LEVEL CTL VAR LEVEL PRESET PHONES REC INHI ON OFF KEY INHI ON OFF SHIFT PAGE HOME CHARACTR ON PB/EE PB CONFI ENABLE CTL/TC TC EMPH EMPH EMPH EMPH 0 0 -10 -10 -20 -20 -30 -30 -40 -40 1 23 4 HD INPUT : ANA CH1 IN : -60 CH2 IN : -4 COND OUT : +4 MONI L : 1 BANK 2 MONI R : 2 D-STOP DOLBY NR P ROLL ASSEMBLE 59.94i SDI ASMBL CONFI ON RECORDER OFF LTC DF VITC LTC EXT-LTC R-RUN REM:00M TCG SET HOME 00:00:00:00. DISPLAY MULTI CONTROL REMOTE MENU RESET PREROLL PUSH PITCH CTL JOG/SHUTTLE REW PLAY F FWD STOP REC PAUSE STANDBY 1 Select STOPCODE on the P6 OTHER page of the function menu. The STOPCODE page appears. Chapter 7 Stop Code 52 Stop Code / Stop Code Operation