Sony HDWS280 Product Manual (Operation Manual 1st Edition (Revised 5)) - Page 58

8-3 UMID Output and Display This section explains how to output and display UMIDs. 8-3-1 UMID Output Settings You can choose to output UMIDs or not and select either Basic UMID or Extended UMID when you choose to output UMIDs. Make these settings using setup menu item 651. For details on setup menu item 651, see page 72. 8-3-2 UMID Display During recording and playback, UMID data appear in the time data display area of the display window and on the video monitor screen. Displaying the UMID Press the UMID function button on the P6 OTHER page of the function menu. For details on function menu operation, see "3-7 Basic Operations of the Function Menu" on page 31. The UMID appears in the time data display area of the display window and on the video monitor screen. For UMID display on the video monitor screen, see " UMID display on the video monitor" on page 58. To switch the displayed UMID item in the time data display area Turn the MULTI CONTROL knob. To exit from UMID display Press the EXIT function button. UMID display on the video monitor The video monitor connected via the COMPOSITE OUT 2 (SUPER) connector, the SDI OUT 2 (SUPER) connector, or the HD SDI OUTPUT (SUPER) connectors on the rear panel displays all UMID items at once. The display of each line is explained below. UMID INFORMATION INSTANCE 24PRS XX-XX-XX 1 MATERIAL SMPTE 2 XX-XX-XX-XX-XX-XX-XX-XX 3 -XX-XX-XX-XX-XX-XX-XX-XX DATE/TIME 20XX/XX/XX XX:XX:XX +XX:XX 4 ALTITUDE XXXXXXXXm 5 LONGITUDE EXXX XX'XX.XX 6 LATITUDE S XX XX'XX.XX 7 ORGANIZATION XXXX 8 USER XXXX COUNTRY XXXX 9 a INSTANCE (Instance Number generation method and Instance Number) The generation method is displayed as follows. CP+16: 16-bit PRS (pseudorandom sequence) +Copy No. method 24PRS: 24-bit PRS method others: Other than the above When menu item 656 is set to NEW, the number is generated in the SMPTE format. For details on setup menu item 656, see page 73. b MATERIAL (Material Number generation method) SMPTE: SMPTE format IEEE 1394 ZONE: IEEE 1394 ZONE format IEEE 1394 RND: IEEE 1394 RND format others: Other than the above c Material Number The material number is displayed in hexadecimal across two lines. The items 4 through 9 below are contained in the Source Pack. d DATE/TIME Date/Time data are displayed across two lines. The upper line shows the MJD (Modified Julian Date) contained in the Source Pack, converted to UTC. The lower line shows the data in unit count format (hours:minutes:seconds) converted to UTC. Note The function for converting unit count to UTC works only when the unit rate is 2 (24 frames), 3 (24/1.001 frames), 4 (25 frames), 6 (30 frames), or 7 (30/1.001 frames). For other unit rates, the unit rate number and unit rate are displayed in hexadecimal. e ALTITUDE XXXXXXXXm: Altitude data indicating the distance from the center of the earth is displayed in this format. Chapter 8 UMID Functions 58 UMID Output and Display