Sony STR-DN2010 Operating Instructions (Large File - 11.22 MB) - Page 118

Subwoofer Level Lets you set the level of the subwoofer to 0 dB or +10 dB when PCM signals are input via an HDMI connection. You can set the level for each HDMI input independently. x 0 dB x +10 dB x AUTO Automatically sets the level to 0 dB or +10 dB depending on the audio stream. Subwoofer LPF (Subwoofer Low Pass Filter for HDMI) Lets you turn the low pass filter for the subwoofer output on or off. The low-pass filter works when PCM signals are input via an HDMI connection. Turn the function on if you connect a subwoofer without the crossover frequency function. x OFF The low pass filter of the subwoofer is turned off. x ON The low pass filter of the subwoofer's cut off frequency is set to 120 Hz. Network Settings menu You can make the settings for the network. Network Setup Lets you make the network settings. To check the network settings 1 Press V/v repeatedly to select "Network Setup", then press . 2 Press V/v repeatedly to select "Network Information", then press . The network setting information of the receiver is displayed on the TV screen. To configure network settings automatically 1 Press V/v repeatedly to select "Network Setup", then press . 2 Press V/v repeatedly to select "Internet Setup", then press . 3 Press V/v repeatedly to select "Connect Automatically (DHCP)", then press . "Success! The receiver is now connected to network." appears on the TV screen. 4 Press to select "Finish". To set the IP address manually 1 Press V/v repeatedly to select "Network Setup", then press . 2 Press V/v repeatedly to select "Internet Setup", then press . 3 Press V/v repeatedly to select "Manual Configuration", then press . The setting screen for the IP address appears on the TV screen. 118GB