Sony STR-DN2010 Operating Instructions (Large File - 11.22 MB) - Page 43
Before you perform Auto, Calibration, Setting up the Auto, Select the speaker pattern,
![]() |
UPC - 027242779938
View all Sony STR-DN2010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Preparing the Receiver Before you perform Auto Calibration Before you perform Auto Calibration, check the following items. • Set up and connect the speakers (page 19, 21). • Connect only the supplied optimizer microphone to the AUTO CAL MIC jack. Do not connect other microphones to this jack. • Set "Sur Back Assign" to "BI-AMP" in the Speaker Settings menu if you use bi-amplifier connection (page 106). • Set "Sur Back Assign" to "SPEAKER B" in the Speaker Settings menu if you use speakers front B connection (page 41). • Pair the surround amplifier to S-AIR main unit if you want to use surround amplifier. • Make sure the speaker output is not set to "SPK OFF" (page 42). • Disconnect the headphones. • Remove any obstacles in the path between the optimizer microphone and the speakers to avoid measurement errors. • Make sure the environment is quiet to avoid the effect of noise and get a more accurate measurement. • Select the seating position as position 1, 2 or 3 to save the Auto Calibration result (page 108). Notes • During the measurement, the sound that comes out of the speakers is very loud. The volume of the sound cannot be adjusted. Pay attention to the presence of children or to the effect on your neighborhood. • If the muting function has been activated before you perform Auto Calibration, the muting function will be set to off automatically. • The measurements may not be performed correctly or Auto Calibration cannot be performed when special speakers, such as dipole speakers are used. 1: Setting up the Auto Calibration Optimizer microphone Example of using surround back speakers 1 Select the speaker pattern (page 40). If you connect front high speakers, select the speaker pattern that has front high speakers (5/x.x or 4/x.x) each time you perform Auto Calibration. Otherwise, the characteristics of the front high speakers cannot be measured. 2 Connect the supplied optimizer microphone to the AUTO CAL MIC jack. 3 Set up the optimizer microphone. Place the optimizer microphone at your seating position. Use a stool or tripod so that the optimizer microphone remains at the same height as your ears. continued 43GB
![](/manual_guide/products/sony-strdn2010-operating-instructions-large-file-1122-mb-5801808/43.png)