Sony STR-DN2010 Operating Instructions (Large File - 11.22 MB) - Page 47
Checking the Auto Calibration, results, When Error Code appears, To save measurement results
UPC - 027242779938
View all Sony STR-DN2010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Checking the Auto Calibration results To check error code or warning message obtained in "2: Performing Auto Calibration" (page 44), proceed with the following steps. Press V/v to select "Warning" in step 7 in "2: Performing Auto Calibration" (page 45) then press . If a warning message appears, check the message and use the receiver without change. Or if necessary, perform Auto Calibration again. When "Error Code" appears Check the error and perform Auto Calibration again. 1 Press to select "Enter". "Retry?" appears on the TV screen. 2 Press B/b to select "Yes", then press . 3 Repeat steps 6 to 7 in "2: Performing Auto Calibration" (page 45). To save measurement results that caused an error without taking a remedy 1 Press V/v repeatedly to select "Save" in step 7 in "2: Performing Auto Calibration" (page 45), then press . 2 Follow the steps in "3: Saving the measurement results" (page 46) to save the measurement results. continued 47GB Preparing the Receiver