Sony STR-DN2010 Operating Instructions (Large File - 11.22 MB) - Page 45
repeatedly and, want to measure, then press
![]() |
UPC - 027242779938
View all Sony STR-DN2010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Preparing the Receiver 3 Press V/v repeatedly to select "Auto Calibration", then press . 4 Press V/v repeatedly to select "Calibration Start", then press . The screen on which you can select the item to be measured appears. 5 Press V/v repeatedly and to uncheck the items you do not want to measure, then press b. The confirmation screen, asking whether you are ready to start measurement, appears. 6 Press to select "Start". The measurement starts in five seconds. The measurement process will take approximately 30 seconds with a test tone. Wait until the measurement process completes. When the measurement ends, a beep sounds and the screen switches. Note If an error code appears on the screen, see "Message list after Auto Calibration measurement" (page 48). 7 Press V/v repeatedly to select the item you want, then press . Item and explanation Retry Performs the Auto Calibration again. Save Saves the measurement results and exits the setting process (page 46). Warning Displays warning concerning the measurement results. See "Message list after Auto Calibration measurement" (page 48). Phase* Displays the phase of each speaker (in phase/ out of phase). Distance Displays the measurement result for speaker distance. Level Displays the measurement result for speaker level. Exit Exits the setting process without saving the measurement results. To save the measurement results, follow the steps in "3: Saving the measurement results" (page 46). If you want to check error code or warning message, see "Message list after Auto Calibration measurement" (page 48). continued 45GB
![](/manual_guide/products/sony-strdn2010-operating-instructions-large-file-1122-mb-5801808/45.png)