Sony STR-DN2010 Operating Instructions (Large File - 11.22 MB) - Page 142
Tuner, HP NO LINK and VOL MIN appear
UPC - 027242779938
View all Sony STR-DN2010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 142 highlights
• Avoid using the equipment that generates electromagnetic energy, such as a microwave oven. • Place the S-AIR main unit and S-AIR sub unit separately from other wireless devices. • Avoid using any other wireless devices. • Change the "RF Change" setting (page 100). • Change the ID settings of the S-AIR main unit and S-AIR sub unit. "HP NO LINK" and "VOL MIN" appear alternately on the display and the volume of the receiver becomes minimum. • Volume becomes minimum when you turn off the surround amplifier with headphones connected or if the radio reception is poor. In these cases, check the radio reception and adjust the volume level to restore sound from the headphones. Tuner The FM reception is poor. • Use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antennas (aerial) as shown below. If you connect the receiver to an outdoor antenna (aerial), ground it against lightning. To prevent a gas explosion, do not connect the ground (earth) wire to a gas pipe. Outdoor FM antenna (aerial) Receiver Radio stations cannot be tuned in. • Check that the antennas (aerials) are connected securely. Adjust the antennas (aerials) and connect an external antenna (aerial), if necessary. • Keep the satellite radio antenna, away from the speaker cords and the power cord to avoid picking up noise.* • The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning. • Make sure you set the tuning interval correctly (when tuning in AM stations with direct tuning). • No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (page 63). • Press AMP, then press DISPLAY repeatedly on the remote so that the frequency appears on the display. The receiver cannot receive satellite channels at all.* • The receiving condition is not good. Move the antenna to the place where the condition is good. • Check that you subscribed to the satellite radio service you want (page 65). RDS does not work.** • Make sure that you are tuned to an FM RDS station. • Select a stronger FM station. The RDS information that you want does not appear.** • Contact the radio station and find out whether they actually provide the service in question. If so, the service may be temporarily out of order. 142GB Ground (earth) wire (not supplied) To ground * USA model only. **European model only.