TP-Link T2500-28TCTL-SL5428E T2500-28TCUN V1 CLI Reference Guide - Page 175
storm-control unicast, bandwidth
View all TP-Link T2500-28TCTL-SL5428E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 175 highlights
T2500-28TC JetStream L2 Managed Switch CLI Guide T2500-28TC(config-if)#storm-control multicast storm-control unicast Description The storm-control unicast command is used to enbale the unicast control function. To disable the unicast control function, please use no storm-control unicast command. Unicast control function allows the switch to filter UL frame in the network. If the transmission rate of the UL frames exceeds the set bandwidth, the packets will be automatically discarded to avoid network broadcast storm. Syntax storm-control unicast [rate rate] no storm-control unicast Parameter rate -- Select the bandwidth for receiving UL-Frame on the port. The packet traffic exceeding the bandwidth will be discarded. By default, the value is "128K". Command Mode Interface Configuration Mode (interface fastEthernet / interface range fastEthernet / interface gigabitEthernet / interface range gigabitEthernet) Example Enable the unicast control function for Fast Ethernet port 5: T2500-28TC(config)#interface fastEthernet 1/0/5 T2500-28TC(config-if)#storm-control unicast bandwidth Description The bandwidth command is used to configure the bandwidth limit for an Ethernet port. To disable the bandwidth limit, please use no bandwidth command. Syntax bandwidth { [ingress ingress-rate] [egress egress-rate] } 158