TP-Link T2500-28TCTL-SL5428E T2500-28TCUN V1 CLI Reference Guide - Page 212

T2500-28TC JetStream L2 Managed Switch CLI Guide destination-ip -- The destination IP address contained in the rule. destination-ip-mask -- The destination IP address mask. It is required if you typed the destination IP address. time-segment -- The time-range for the rule to take effect. By default, it is not limited. frag -- Enable/Disable Fragment. By default, it is disabled. If Fragment is enabled, this rule will process all the fragments and the last piece of fragment will be always forwarded. dscp -- Specify the dscp value, ranging from 0 to 63. s-port -- The source port number. d-port -- The destination port number. tcpflag -- Specify the flag value when using TCP protocol. protocol -- Configure the value of the matching protocol. icmptype -- Configure the predefined ICMP type. icmpcode -- Configure the predefined ICMP code. tos-- Enter the IP ToS contained in the rule. pri -- Enter the IP Precedence contained in the rule. Command Mode Global Configuration Mode Example Create an Extended-IP ACL whose ID is 220, and add Rule 10 for it. In the rule, the source IP address is 192.168.0.100, the source IP address mask is 255.255.255.0, the time-range for the rule to take effect is tSeg1, and the packets match this rule will be forwarded by the switch: T2500-28TC(config)#access-list create 220 T2500-28TC(config)#access-list extended 220 rule 10 permit sip 192.168.0.100 smask 255.255.255.0 tseg tSeg1 access-list combined Description The access-list combined command is used to add combined ACL rule. To delete the corresponding rule, please use no access-list combined command. 195