TP-Link T2500-28TCTL-SL5428E T2500-28TCUN V1 CLI Reference Guide - Page 245
ethernet-oam remote-failure
View all TP-Link T2500-28TCTL-SL5428E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 245 highlights
T2500-28TC JetStream L2 Managed Switch CLI Guide Example For error frame seconds event, configure the error threshold as 8 and the event detection interval as 30 seconds on Fast Ethernet port 5: T2500-28TC(config)# interface fastEthernet 1/0/5 T2500-28TC(config-if)# ethernet-oam link-monitor frame-seconds threshold 8 window 300 ethernet-oam remote-failure Description The ethernet-oam remote-failure command is used to configure whether to notify the link faults or not. The link faults include dying gasp and critical event. To return to the default configurations, please use no ethernet-oam remote-failure command. Syntax ethernet-oam remote-failure { dying-gasp | critical-event } notify { disable | enable } no ethernet-oam remote-failure { dying-gasp | critical-event } notify Parameter dying-gasp -- Dying Gasp link event. Dying gasp means an unrecoverable fault, such as power failure, occurs. critical-event -- Critical Event. Critical-event means unspecified critical event occurs. notify --Enable/Disable the event notification. By default, it is enabled. Command Mode Interface Configuration Mode (interface fastEthernet / interface range fastEthernet / interface gigabitEthernet / interface range gigabitEthernet) Example Disable the Dying Gasp link event notification on Fast Ethernet port 7: T2500-28TC(config)# interface fastEthernet 1/0/7 228