TP-Link T2700G-28TQ T2700G-28TQ User Guide V1 - Page 266
PIM SM Interface, 11.4.2 PIM SM Neighbor, Select, Interface, Status, Hello Interval
View all TP-Link T2700G-28TQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 266 highlights
The multicast messages (such as C-RP Hello Message and BSR BootStrap Message) of each BSR administrative domain can't pass through the domain border. 11.4.1 PIM SM Interface Choose the menu Multicast Routing→PIM SM→PIM SM Interface to load the following page. Figure11-20 PIM SM Interface The following entries are displayed on this screen: PIM SM Interface Config The L3 interfaces can be configured as PIM SM mode by this page. Select: Interface: Status: Hello Interval: Join/Prune Interval: DR Priority: BSR Border: IP Address: Neighbor Count: DR Address Select the desired interface to configure. Displays the VLAN interface which you can configure. Select to enable or disable PIM SM function on the interface. Specify the rate (time in seconds) at which PIM hello messages are transmitted from the selected interface. The valid value ranges from 1 to 18725 seconds and the default is 30 seconds. Specify the frequency at which PIM Join/Prune messages are transmitted on this PIM interface. The valid value range from 1 to 18724 seconds and the default value is 60 seconds. Specify the DR priority for the selected interface. The valid value range from 0 to 4294967294. The default value is 1. Select to enable or disable the BSR border to define a PIM bootstrap message boundary for the PIM domain. Displays the IP address of the interface. Displays the number of PIM neighbors of this interface. Displays the DR address of the interface. 11.4.2 PIM SM Neighbor PIM SM neighbor is automatically learned by sending and receiving Hello Packets when PIM SM is enabled. 254