Toshiba Tecra A3-S711 User Manual - Page 127

Power System Retaining data with power off (standby mode) When you turn off your computer with fully charged batteries, the batteries retain data for the following approximate time periods: Battery Approximately 2 days (Standby mode, 12-cell) Approximately 1 days (Standby mode, 6-cell) Approximately 1 month (Shut down mode, both) RTC battery Approximately 1 month Extending battery life To maximize the life of your battery pack: ■ If you have extra battery packs, rotate their use. ■ If you will not be using the system for an extended period, remove the battery pack. ■ Store spare battery packs in a cool dry place out of direct sunlight. Replacing the battery pack When the battery pack reaches the end of its operating life you will need to install a new one. If the Battery indicator flashes amber shortly after the battery has been fully recharged, the battery pack needs to be replaced. You might also replace a discharged battery pack with a charged spare when you are operating your computer away from an AC power source. This section explains how to remove and install the battery pack. Removing the battery pack To replace a discharged battery pack, follow the steps below. ■ When handling battery packs, be careful not to short circuit the terminals. Also do not drop, hit or otherwise apply impact; do not scratch or break the casing and do not twist or bend the battery pack. ■ Do not remove the battery pack while the computer is in Standby mode. Data in memory will be lost. 1. Save your work. 2. Turn the computer's power off. Make sure the Power indicator is off. 3. Remove all cables connected to the computer. 4. Turn the computer upside down. 5. Unlock the Battery Pack Lock. 6. Unlock the Battery Pack Release Latch. 7. Slide the battery latch to the left, then pull the battery out of the battery bay. TECRA A3/S2 6-10