Yamaha RXV1800 Owner's Manual - Page 108

Remote control features Programming codes from other remote controls You can program remote control codes from other remote controls. Use the learn feature if you want to program functions not included in the basic operations covered by the remote control codes, or an appropriate remote control code is not available. You can program the function of other remote control to the buttons in the highlighted areas in the following illustration. The buttons can be programmed independently for each input area. POWER TV POWER AV STANDBY POWER XM AUDIO SEL SLEEP TUNER CD CD-R MULTI CH IN MD/TAPE DVD BD/HD DVD PHONO DTV/CBL DVR VCR V-AUX/DOCK ++ TV VOL CH -- SELECT + VOLUME - AMP SOURCE TV Set to SOURCE TV MUTE LEVEL TITLE BAND TV INPUT MUTE PRESET/CH SET MENU MENU SRCH MODE PURE DIRECT LEVEL TITLE BAND PRESET/CH SET MENU MENU SRCH MODE PURE DIRECT ENTER AUDIO A-E/CAT. RETURN XM MEMORY 1 PARAMETER STRAIGHT DISPLAY EFFECT SYSTEM MEMORY 2 3 4 CLASSICAL LIVE/CLUB ENTERTAIN 5 6 7 MOVIE 8 STEREO ENHANCER SUR. DECODE 9 0 +10 ENT REC DISC SKIP OFF ON MACRO LEARN CLEAR RENAME SELECT V-AUX/DOCK VCR DVR DTV/CBL DVD BD/HD DVD PHONO MD/TAPE CD-R MULTI CH IN CD TUNER AUDIO SEL SLEEP XM POWER AV POWER TV POWER STANDBY 2 Place this remote control about 5 to 10 cm (2 to 4 in) apart from the other remote control on a flat surface so that their infrared transmitters are aimed at each other. Other remote control 5 to 10 cm (2 to 4 in) 3 Press LLEARN using a ballpoint pen or similar object. "LEARN" and the name of the selected input area (e.g. "DVD") appear alternately in the display window (A) on the remote control. Note The remote control transmits infrared rays. If the other remote control also uses infrared rays, this remote control can learn most of its functions. However, you may not be able to program some special signals or extremely long transmissions. Refer to the operating instructions for the other remote control. 1 Set the operation mode selector to CSOURCE and then press an input selector button (1) or to select an input area. LEARN Notes • Do not press and hold LLEARN. If you hold it down for more than 3 seconds, the remote enters the remote control code setting mode. • If you do not complete each of the following steps within 30 seconds, the learning mode will be automatically canceled. In this case, start over from step 3. Note Make sure that the operation mode selector is set to CSOURCE. When you set the operation mode selector to CAMP and program a remote control codes from other remote controls, the programmed key cannot operate the amplifier function of this unit. 4 Press the button for which you want to program the new function. "LEARN" appears in the display window (A) on the remote control. 104 En