Yamaha RXV1800 Owner's Manual - Page 23

PREPARATION ■ Connecting the banana plug (Except U.K., Europe, Asia and Korea models) 1 Tighten the knob using the supplied speaker terminal wrench. Speaker terminal wrench Connections ■ Using bi-amplification connections Caution Remove the shorting bars or bridges of your speakers to separate the LPF (low pass filter) and HPF (high pass filter) crossovers. This unit allows you to make bi-amplification connections to one speaker system. Check if your speakers support biamplification connection. To make the bi-amplification connections, use the FRONT and SURROUND BACK/BI-AMP speaker terminals as shown below. To activate the bi-amplification connections, set "BI-AMP" to "ON" in "ADVANCED SETUP" (see page 120). Red: positive (+) Black: negative (-) This unit 2 Insert the banana plug connector into the end of the corresponding terminal. Banana plug R + SURROUND BACK/ BI-AMP SINGLE L + R SURROUND L + + R FRONT L + + y You can also use the banana plug with the SP2 speaker terminals. Open the tab and then insert one banana plug into the hole on the terminal. Do not close the tab after connecting the banana plug. Right Left Front speakers Note When you make the conventional connection with the speakers, make sure that the shorting bars are put into the terminals of the speakers appropriately. Refer to the instruction manuals of the speakers for details. English 19 En